Kenwood TS-60S Instruction Manual page 38

5 SCAN
3533550.
2 Select memory channel 99 using the UP or
DOWN button.
Example: 51.000 MHz is stored in memory
channel 99.
3 Press the F.LOCK button. The F.LOCK indicator
appears.
FLOCK
4 Display the start frequency by pressing the DOWN
button, and the end frequency by pressing the UP
button.
Switch the F.LOCK button off to change the
operating frequency using the tuning control.
5 To return to the VFO mode, switch off FLOCK
and press the M/V button.
MEMORY CHANNEL LOCK-OUT
Select memory channels to be skipped during memory
scan with this procedure:
1 Press the M/V button to change from VFO to
Memory Channel mode. The last memory channel
number selected appears.
+> mo Ome
353355o..
2 Use the UP or DOWN button to select the
memory channel to be skipped.
Example: Recall memory channel 14, containing
50.040 MHz.
3 Momentarily press the CLR button. A dot appears
beside the memory channel number to indicate the
channel has been locked-out.
=
0420.
Ce ow
4 Momentarily press the CLR button again, and
lock-out for that memory channel is canceled and
the dot is cleared.
§ In order to restore the VFO mode, press the MV
button, or press the M>V button to transfer the
memory data to the VFO.
Note:
1 If you hold the CLA button for more than 2 seconds, the
currently selected channel contents will be erased.
2 Ifyou attempt to scan the memories, and have locked-out ail
memory channels containing data, a Morse code "CHECK"
alarm will sound.
3 Even when Memory Protect t or 2 is on, you can lock-out or
unlock memory channels,
4 Memory channel 99 is locked-out automatically after the first
use of program scan.
38