Kenwood TS-60S Instruction Manual page 15

2 CONTROLS AND CONNECTORS
a2 @ @®
| I
us KENWOOD. nove au WOOE TRANSCEOAA 18-80
i Wea AE AT NA FG PU FAST SW GY ®
a [e888 888. ae. o
— Pin, sen ose
= 156 Usa EWN FMAM TONE /
a © sat o © swe
CMO —-@
Sec @
® ON AIR indicator
Lights when the transceiver is both in the transmit
mode and tuned to a frequency within the transmit
band. If the microphone PTT switch is pressed while
tuned to a frequency outside the transmit band, no
signal can be transmitted. The PTT must be released
first, a frequency tuned within the transmit band, and
the PTT pressed again before transmission is
possible.
@® BUSY indicator
Lights when the squelch is opened, either by the SQL
control or by a received signal.
® F.LOCK button
Locks or unlocks the tuning control and these buttons:
« AB
eA=8B
# CLR
* DOWN
@ FM/AM
@ MIN
oMVv
eM>V
@ MHz
@ SCAN
@ SPLIT
® SSB/CW
@ UP
NB
Press this button momentarily, and "F.LOCK" appears
on the display top right, to indicate that lock is on.
Release lock by again pressing the button.
15
i) @
@ MHz button
Toggles the function of the UP and DOWN buttons.
The "1 MHz" indicator appears at the top right of the
LCD to indicate status.
Switch the MHz button on:
in the VFO mode, to change the operating frequency
in 1 MHz steps (1 MHz on).
In the Memory Channel mode, to select either from
only loaded memory channels (on), or fram all memory
channels (off). For details, refer to "QUICK MEMORY
CHANNEL SELECT" on page 36.
In the Memory Scroll mode, to select only from empty
memory channels. For details, refer to "QUICK
MEMORY CHANNEL SELECT" on page 36.
@ UP and DOWN buttons
The UP and DOWN buttons have these five functions:
® Amateur sub-band select
@ Frequency up or down in 1 MHz steps
©@ Memory channel select
® Menu setting select
® Start and end frequency recall (when memory
channel 99 is selected)
(1) Amateur sub-band select
In the VFO mode, with the 1 MHz indicator off,
step through the Amateur sub-bands (page 41).
Press the UP button, and the next higher band will
be selected, Select the next lower band by
pressing the DOWN button. Hold down either
bution for rapid change.
(2) Frequency up or down in 1 MHz steps
In the VFO mode, with the 1 MHz indicator on,
step the frequency up or down in 1 MHz steps.
Press the UP button to increase, or the DOWN
button to decrease the frequency. Hold down
either button for rapid change.
Note: The frequency step may be changed from 1 MHz
to 500 kHz. Far details, refer to Menu Set-up (Menu B,
No. 62) on page 47.