Kenwood TS-60S Instruction Manual page 37

5 SCAN
MEMORY SCAN
The transceiver will scan all memory channels
containing data (All-channel Scan) or only the selected
channel group (Group Scan). For the selection
method, refer to Menu Set-up (Menu A, No. 13). The
factory default is Group Scan.
GROUP SCAN
There are 100 memory channels, divided into groups
of 10 channels (00 to 09, 10 to 19, ..., 90 to 99). The
transceiver scans only memory channels which belong
to the specified group, contain data, and are not
locked-out. Storing data in memory channel 99
automatically locks-out that channel. Unlock memory
channel 99 if you wish to scan it. Refer to "MEMORY
CHANNEL LOCK-OUT" on page 38.
1 Press the M/V button to change from VFO to
Memory Channel mode. The last memory channel
number selected appears.
ao. e we
521950.
2 Use the UP or DOWN button to select any
memory channel belonging to the desired group.
Adjust the SQL control while no signal is present.
Example: To scan channels 10 to 19, select
memory 12, for instance.
S4335Sa.
2 use
3 Press the SCAN button. The transceiver scans
the specified group.
4 To switch the channel group during scan, use the
microphone UP and DWN buttons.
5 To stop scan, press the SCAN or CLR button, or
press the microphone PTT button momentarily.
6 To restore the VFO mode, stop scan and then
press the M/V button, or press the M>V button to
transfer the memory data to the VFO.
Note: if no data is stored in any memories of a group, or
you have locked-out ail memories of a group, pressing the
SCAN key will sound the Morse code "CHECK" reminder.
37
ALL-CHANNEL SCAN
Sean all memory channels containing frequency data
that are not locked-out with this procedure:
1 Press the M/V button to change from VFO to
Memory Channel mode. The last memory channel
number selected appears.
Adjust the SQL control while no signal is present.
Remember, Menu A, No. 13 must be ON.
Rsaasso. |
uae
2 Press the SCAN button. The SCAN indicator
appears, and alt occupied memory channels are
scanned.
wT BLOW
won IAC A
521758... et
Bek ye we as
3 The UP and DOWN buitons on the transceiver
and microphone operate during scan.
4 To stap scan, press the SCAN or CLR button.
Or, momentarily press the microphone PTT
button.
5 To restore the VFO mode, stop scan and press
the MMV button, or press the M>V button to
transfer the memory data to the VFO.
Note; if no data is stored in the memories, or you have
locked-out all memories, pressing the SCAN key will sound
the Morse code "CHECK" reminder.