Kenwood TS-60S Instruction Manual page 25

3 COMMUNICATION
RECEPTION
1 Switch on the DC power supply, and then switch 1
on the transceiver. 2
2 After the "HELLO" message, the frequency and
the other indicators will appear on the display.
S mannn
ae See Be 2 eo een
3 tT ee oti "3
3. Select the receive frequency using the UP and
DOWN buttons and the tuning control.
The frequency may be changed in 1 MHz steps 7
using the UP or DOWN button (1 MHz indicator
on}.
4 Use the FM/AM button to select the FM mode.
! i mM
§ 12 /5.8..
5 Set the AF control to a comfortable listening level.
6 FM background noise will be heard when no signal 6
is present. Adjust the SQL control until the noise
just disappears (threshold).
7 Adjust the tuning control for clearest reception.
25
TRANSMISSION
Plug the microphone in and secure the connector.
Use the UP and DOWN buttons and the tuning
control to select the transmit frequency.
The frequency may be changed in 1 MHz steps
using the UP or DOWN button (1 MHz indicator
on).
Use the FM/AM button to select the FM mode.
Hold the microphone PTT switch to transmit.
Be courteous; make sure that your transmission
doesn't interfere with others.
Speak into the microphone.
A YFO
2 15.0..
HSE id
St
Pa
Note: Speak in a normal tone of voice. The AF meter will
indicate a steady carrier, regardiess of voice peaks.
Speaking too close to the microphone, or too loudly may
increase distortion and reduce intelligibility. If operating
through a repeater, over deviation will cause your signal to
"talk-off" (break up) through the repeater.
Release the PTT switch to receive.