Seats; Seat Care; Seat Lock - Triumph Speed 400 Owner's Handbook Manual

GENERAL INFORMATION
56
Right Hand Side Panel
To install the right hand side panel:
Position the bottom of the side
▼
panel onto the lower hook.
Position the two locating dowels to
▼
the grommets, then press firmly to
secure the panel.
Install the fastener at the top of the
▼
side panel and tighten to 40 lbf in
(4.5 Nm).
Finally, grasp the panel and make
▼
sure it is fully retained.
2
clgd
1. Side panel (Scrambler 400 X shown)
2. Hook
3. Grommets
Reinstall the seat for Speed 400 and
▼
the rider and passenger seats for
Scrambler 400 X, see page 58.
3
1

Seats

Seat Care

NOTICE
To prevent damage to the seats or
seat covers, care must be taken not to
drop the seats.
Do not lean the seats against the
motorcycle or any surface which may
damage the seats or seat covers.
Instead, place the seats, with the seat
cover facing upwards, on a clean, flat
surface which is covered with a soft
cloth.
Do not place any item on the seats
which may cause damage or staining
to the seat covers.
For seat cleaning
page 143.

Seat Lock

WARNING
To prevent detachment of the seat
during riding, after installation always
grasp the seat and pull firmly upwards.
If the seat is not correctly secured in
the lock, it will detach from the lock.
A loose or detached seat may lead to
loss of motorcycle control which could
result in serious injury or death.
NOTICE
The motorcycle must not be ridden
with the key in the seat lock.
Always lock the seat and remove the
key before riding the motorcycle.
information, see