Triumph Speed 400 Owner's Handbook Manual page 67

NOTICE
The low oil pressure warning light
should go out shortly after the engine
starts.
If the low oil pressure warning light
remains on after starting the engine,
stop the engine immediately and
investigate the cause.
Running the engine with low oil
pressure will cause severe engine
damage.
5
1
2
4
3
1. STOP position
2. RUN position
3. START button
4. LOCK position
5. OFF position
6. ON position
7. Ignition switch
8. Neutral indicator light
9. Gear position display (neutral shown)
Check that the engine stop switch is
▼
in the RUN position.
Make sure the transmission is in
▼
neutral.
Turn the ignition switch on.
▼
NOTICE
When the ignition is switched on,
the instrument warning lights will
illuminate and will then go off (except
those which normally remain on until
the engine starts, see page 27).
HOW TO RIDE THE MOTORCYCLE
6
9
7
8
Pull the clutch lever fully into the
▼
handlebar.
Leaving the throttle fully closed,
▼
push the START button until the
engine starts.
The motorcycle is equipped with
▼
starter lockout
switches prevent
starter from operating when the
transmission is not in neutral with
the side stand down.
If the side stand is extended while
▼
the engine is running, and the
transmission is not in neutral then
the engine will stop regardless of
the clutch lever position.
switches. The
the electric
67