Breaking-In New Brake Discs And Pads - Triumph Speed 400 Owner's Handbook Manual

Brake pads must
in accordance
requirements and replaced if worn to, or
beyond the minimum service thickness.
2
cler
1. Carrier plates (Speed 400 shown)
2. Brake pads
3
2
clek
1. Carrier plate (Speed 400 shown)
2. Brake pad lining
3. Minimum thickness line
Brake pads for this model supplied
by Triumph will have the carrier plate
at the recommended thickness. We
recommend that the brake pads are
changed by a competent person with
the specialist knowledge and technical
understanding of motorcycles, such as
an authorized Triumph dealer.
MAINTENANCE AND ADJUSTMENT
be inspected
with scheduled
1
1
If the lining thickness of any brake pad
is less than that specified in the table,
replace all the brake pads on the wheel.
Speed 400
Carrier plate 0.138 in
thickness (3.5 mm)
Front brake
pad lining 0.0394 in
minimum (1 mm)
thickness
Minimum
service
thickness 0.18 in
(Brake pad (4.5 mm)
lining and
carrier plate)
Minimum
service
thickness
(Brake pad -
lining, carrier
plate and
shim)
Breaking-in New Brake Discs and
Pads
WARNING
Brake pads must always be replaced
as a wheel set. At the front, replace all
the brake pads in the caliper.
After replacement brake pads have
been installed, ride with extreme
caution until the new pads have
'broken in'.
Replacing individual pads will reduce
braking efficiency and may lead to
loss of motorcycle control which could
result in serious injury or death.
107
Scrambler 400 X
0.147 in (3.74 mm)
0.0197 in (0.5 mm)
-
0.167 in (4.24 mm)