Install the engine oil filter and cover,
▼
and tighten the fasteners to 8 lbf ft
(11 Nm).
4
cldq
1.
Engine oil filter cover
2.
Engine oil filter cover fasteners
3.
Engine oil filter cover O-ring
4.
Engine oil filter
Install the engine oil strainer.
▼
Install and tighten the engine oil
▼
drain plug to 10 lbf ft (13 Nm).
Engine Oil Filling
Remove the engine oil filler plug.
▼
Using a suitable funnel, fill the
▼
engine with a fully synthetic 10W/50
motorcycle engine oil which meets
specification API SN (or higher) and
JASO MA2. Semi synthetic engine
oil must not be used. Triumph
Performance fully synthetic engine
oil is recommended.
MAINTENANCE AND ADJUSTMENT
1
2
3
NOTICE
The engine oil grade specified must be
used.
Using the incorrect engine oil grade
may result in engine damage.
2
4
3
clfv
1.
Engine oil filler plug
2.
Sight glass
3.
Lower marking (minimum)
4.
Upper marking (maximum)
Start the engine and allow it to idle
▼
for a minimum of 30 seconds.
NOTICE
Raising the engine speed above idle
before the oil reaches all parts of the
engine can cause engine damage or
seizure.
Only raise engine speed after running
the engine for 30 seconds to allow the
oil to circulate fully.
Make sure that the low oil pressure
▼
warning light remains off.
1
2
93