Safety Instructions - PROLiNK Giant II Series User Manual

2-2. Safety Instructions

COMMEMORATION! Before installing and using this equipment, please read all UPS instructions and
warning signs in this manual. Keep this manual in a place that can be easily accessed.
COMMEMORATION! This guide is only for qualified personnel. The tasks described in this guide can only be
performed by expert technicians.
COMMEMORATION! This equipment must be installed by qualified personnel.
COMMEMORATION! Make sure that the cross-sectional size of the earth cable must be equal to or larger
than the power cable connected to the grounding.
COMMEMORATION! Make sure the UPS is properly insulated with a grounding shield when installed and
before operating the UPS.
COMMEMORATION! UPS should be used for IT distribution systems.
ATTENTION! The output neutral is the same as the UPS input neutral (non insulating type). For the correct
operation of the UPS, a neutral insert wire must be connected. It can cause power loss without neutral input.
ATTENTION! Please charge the battery first before using the UPS for the first time or When not using the UPS
for a long period of time (maximum 6 months)
COMMEMORATION! Never manipulate equipment with wet hands.
ATTENTION! To avoid the risk of fire and electric shock, make sure the existing cables are in good condition
and the cables are not too small. Do not operate the Inverter with damaged or substandard cables.
COMMEMORATION! When the UPS power supply is off due to a signal from the EPO, the UPS still has a
power source. To turn off the power, turn off all input power on the UPS.
COMMEMORATION! Authorized service personnel should reduce the risk of electric shock by unplugging
both AC and DC power from the UPS before performing maintenance or or working on any circuits
connected to the inverter. Turning off the controls will not reduce this risk. Internal capacitors still have
electric current even though they have disconnected all existing power sources.
ATTENTION! Do not open, disassemble or modify the equipment yourself. Repairing this equipment yourself
may cause a risk of electric shock or fire and may void the manufacturer's warranty.
ATTENTION! Turn off the UPS immediately if smoke or gas is found coming out of the UPS.
6