Honda CR125R 1992 Service Manual page 142

Front Wheel/Suspension/Steering
Remove the spring seat from the fork cap.
Remove the fork spring.
CAUTION
• When the fork cap is removed from the damper rod, the
slider can move up and down freely on the outer tube.
Always hold both the outer tube and slider with your
hands after removing the fork cap, or the guide and slide
bushings might be damaged and fork oil will leak from
the slider.
Remove the lock nut and spring guide.
Pour out the fork oil.
Remove the distance collar, rebound needle and spring from
the damper rod.
Set the lower end (axle holder) of the slider in a vise with a
piece of wood or soft jaws to avoid to damage.
CAUTION
J •
Do not over tighten the axle holder.
Loosen and remove the center bolt and sealing washer.
NOTE
• If the center bolt turns together with the fork damper,
temporarily install the· fork spring and cap.
X
f
( 1) DISTANCE COLLAR
11-10
RICIERED
~
(1)
SPRING GUIDE
(3) SPRING