Table of Contents
Advertisement
Load a media roll
Introduction
You can load standard and custom media on your printer.
Before you begin
Before you load a roll on the printer, make sure your media is enabled.
• For standard media you must enable a media profile in WebTools Express. For more
information, see
• Make sure the size is enabled in WebTools Express. For more information, see
media sizes on page
media size. For more information, see
IMPORTANT
• Do not use dented media rolls to prevent damage to the imaging devices.
• Do not open the media drawer during the print process.
• Do not open more than one media drawer at the same time to prevent overbalance of the
printer.
CAUTION
Watch your fingers when you handle the media roll.
Procedure
1. Pull firmly to open the media drawer.
2. Place the new media roll on the roll loading station.
Configure the media profiles on page
188. If your media size is not present in the list, you can create a custom
185.
Create a custom media size on page
Chapter 5 - Maintain the printing system
Load a media roll
Configure the
187.
285
Advertisement
Table of Contents
