Table of Contents
Advertisement
Configure the network and security settings
Configure the network settings in WebTools Express
Introduction
Some of the network settings are configured during the installation of your system. When you
want to define more network settings, you can do so under the [Configuration] tab.
NOTE
For more detailed information on network settings, refer to the ColorWave-Plotwave
Connectivity Manual for Windows.
Procedure
1. Open the [Configuration] - [Connectivity] tab.
2. Click [Edit] in the upper right hand corner of the [Network adapter] section, the [Network adapter:
IPv4] section or the [Network adapter: IPv6] section. Here you can edit all the settings of the group
in one window.
or
3. Click on a single setting in the list to edit only one setting.
NOTE
You can always find a short explanation of the setting in the tooltip.
4. Click [Ok] to confirm, or [Cancel] to reject your entries.
Configure the network and security settings
Chapter 3 - Define your workflow with WebTools Express
83
Advertisement
Table of Contents
