Set the link speed and duplex mode
Set the link speed and duplex mode
Introduction
Use WebTools Express to set the transmission speed and duplex mode for your network adapter.
Before you begin
NOTE
The list of values you can select depends on the network card type.
Procedure
1. Open the [Configuration] - [Connectivity] tab.
2. Click on [Edit] in the [Network adapter] section or click on the [Link speed and duplex mode]
setting.
3. Select the value. [Automatic detection] is default.
4. Click on [Ok] to confirm or [Cancel] to reject your entries.
88
Chapter 3 - Define your workflow with WebTools Express