Table of Contents
Advertisement
Enable Access control
Enable Access control
Introduction
When you want to control access to your printer, you need to enable access control in WebTools
Express. With access control enabled, you are able to choose up to five hosts who are allowed to
communicate with the printer through your network. This amount of hosts allows for flexible
configuration.
For each of the hosts you can decide whether the communication from this host to the system
needs to be encrypted by IPsec.
Procedure
1. Open the [Security] - [Configuration] tab.
2. In the [Access control] section, click on the [Access control] setting.
3. Change the [Access control] setting from [Disabled] to [Enabled]. The setting is enabled when you
check the box.
4. Click OK to confirm.
90
Chapter 3 - Define your workflow with WebTools Express
Advertisement
Table of Contents
