Table of Contents
Advertisement
Adjust the media properties
Introduction
When you create a custom media type and choose the right media category, the media properties
are automatically selected. These media properties are the optimized settings for the selected
media category.
In some cases, you may still want to adjust the media properties. Use the overview to change the
properties accordingly.
IMPORTANT
Changing the default media properties is at your own risk. Note that it can impact the quality of
the print or it can cause a paper jam.
Media properties
Setting
[Carriage eleva-
tion]
[Compatible with
the embedded
knife]
[Compatible with
folding devices]
Value
The default value is [automatic].
Select [maximum] when:
• Media touches occur.
• The edges of the media are wavy.
• The edges of the media curl, caused by stress in the media or a high ink
coverage (e.g. transparent papers).
• The type of media is not flat by nature. Lay a large sheet, 1 m², flat on a
table to check (e.g. Tyvek).
• Media touches caused by wrinkling occur.
Wrinkling because of special media (e.g. vinyl, film etc.) or high humid
conditions (e.g. paper or self-adhesive).
When you can cut the media select [yes]. You can cut:
• Media that you can tear by hand.
• Plain paper 60-120 g/m²
When you cannot cut the media select [no]. You cannot cut:
• Textile
• Canvas
High-weight paper, thick film and thick self-adhesive media are difficult to
cut. When you make the wrong choice and media cannot be cut, an error
message appears on the user panel.
Select [yes] for media compatible with the folder:
• Plain paper 60-120 g/m²
• Vellum (quality not guaranteed)
• Translucent (quality not guaranteed)
• Tyvek (quality not guaranteed)
Chapter 3 - Define your workflow with WebTools Express
Adjust the media properties
183
4
Advertisement
Table of Contents
