Make A Scan And Remove A Strip - Canon ColorWave 3800 Operation Manual

Make a scan and remove a strip

Introduction
If you have an original with a strip, you can remove the strip from your scanned file.
Use the option [Remove strip] on the user panel to scan an original with a strip and remove the
strip from the file. You can remove a strip from the top, the bottom, the left or the right side of the
original.
Procedure
1. Feed the original face up and centered on the original feeding table.
2. Tap the scan tile on the user panel and select your preferred template in the scan Smart Access.
3. Tap the scan tile again.
4. Tap [Remove strip] under the [Original] category.
[Remove top strip]
5. Select [Remove top strip], [Remove bottom strip], [Remove left strip], or [Remove right strip] and
define the values.
6. Make your settings and tap [OK].
7. Tap the green button.
Result
The printer scans the original to file without the defined strip. The file is sent to the location
defined in the template.
[Remove bottom strip]
Make a scan and remove a strip
[Remove left strip]
Chapter 4 - Use the printing system
[Remove right strip]
267