Elvis Voltage Selection Jumper (Jp6); Elvis Select Jumper (Jp8) - Analog Devices Lite ADSP-BF538F EZ-KIT System Manual

Jumper and Switch Settings

ELVIS Voltage Selection Jumper (JP6)

ELVIS Select Jumper (JP8)

2-16
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
The ELVIS voltage selection jumper (
source for the EZ-KIT Lite. In a standard mode of operation, the board
receives its power from an external power supply. When
the board is powered from an ELVIS station, and no external power sup-
ply is required. The jumper setting is shown in
Table 2-12. ELVIS Voltage Selection Jumper (JP6)
JP6 Setting Mode
OFF Powered from an external power supply (default)
Powered from an ELVIS station
ON
The external power supply must be disconnected from the board
when is installed. Otherwise, the power supply can cause dam-
JP6
age to the EZ-KIT Lite board and ELVIS unit.
The ELVIS select jumper (
to an ELVIS station (see
installed, the connections to the push buttons and LED are re-directed to
the ELVIS station, instead of the processor. The jumper setting is shown
in Table 2-13.
Table 2-13. ELVIS Select Jumper (JP8)
JP8 Setting Mode
OFF Not connected to an ELVIS station (default)
Connected to an ELVIS station
ON
ADSP-BF538F EZ-KIT Lite Evaluation System Manual
) is used to select the power
JP6
Table
) configures the EZ-KIT Lite's connection
JP8
"ELVIS Interface" on page
is installed,
JP6
2-12.
1-12). When is
JP8