Push Button Enable Switch (Sw5); Adsp-Bf538F Ez-Kit Lite Evaluation System Manual; Flash Enable Switch (Sw6) - Analog Devices Lite ADSP-BF538F EZ-KIT System Manual

Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
ADSP-BF538F EZ-KIT Lite Hardware Reference

Push Button Enable Switch (SW5)

The push button enable switch (
the push button circuit drivers from the GPIO pins of the processor.
When the switch is in the
SW5
(see Table 2-5) can be used on the expansion interface.
Table 2-5. Push Button Enable Switch (SW5)
Push Button
( )
PB1 SW13
( )
PB2 SW12
( )
PB3 SW11
( )
PB4 SW10

Flash Enable Switch (SW6)

The flash enable switch (
nal flash memory, allowing other devices to utilize the signals via the
expansion interface. For each switch listed in
the size of available flash memory is reduced by 1 MB.
Table 2-6. Flash Enable Switch (SW6)
Processor Signal
~AMS0
~AMS1
~AMS2
~AMS3

ADSP-BF538F EZ-KIT Lite Evaluation System Manual

) disconnects the associated signal and
SW5
position, the GPIO signal
OFF
SW5 Switch Position (Default)
1 ( )
ON
2 ( )
ON
3 ( )
ON
4 ( )
ON
) disconnects the
SW6
SW6 Switch Position (Default)
1 ( )
ON
2 ( )
ON
3 ( )
ON
4 ( )
ON
Processor Signal
PF0
PF1
PF2
PF3
signals from the exter-
~AMS
Table 2-6 that is turned ,
OFF
2-11