Table of Contents
Advertisement
Crusader
MC-8
[ "Gf _ _ _
3_-_3_2 ____
DATE
MAINTENANCE
September, 1975 ]
MANUAL
SIGN CURTAIN REPAIR
In event a destination si.gn curtain is torn, it can be
repaired with 3M polyester tape or any equivalent
cellophane tape. When repairing a tear, the tape
should be used on both sides of the curtain.
When it becomes necessary to install or add curtain
inserts in either cloth or mylar curtains the following
procedure should be followed: Butt splice or overlap,
and apply a strip of 3/4" wide polyester tape over front
and rear seam.
The above method is much easier and more accurate
way of installing inserts. It also makes for consider-
ably less bulk and better tl¼rning curtain rolls.
DRIVER'S SEAT
ADJUSTMENT
The driver's seat may be adjusted for and aft by
pushing in lock lever located at left front of seat.
When seat is positioned, release lever. The back of
the seat cushion can be tilted up or down by grasping
a large knob at left corner of driver's seat and turning
forward to lower and backward to raise. Seat may be
raised by grasping and firmly pulling seat frame up.
To lower, raise seat to highest position, then lower
seat to lowest position. From there raise seat to
desired height.
Puah Button to
Ret••••
Insert until ••Click .. to Fasten
..........
,
.•.....
~
~~
.
~
Insert until .. Click" to F••Hn
TIit Down to Loosen
Figure 3 - 21: Seat Belt Lock
Mechanism
CAUTION: Seat belts are to be worn at all times.
For maximum protection they should be pulled tight
to fit snugly -
with webbing bearing on hip bones
and pulling downward and rearward at 45 degree
angle.
MAINTENANCE
It is strongly recommended that floor fittings be in-
spected for looseness and the floor checked for
corrosion at least twice a year. If it becomes
necessary to clean the webbing, use a mild detergent
with lukewarm water. Do not re-dye or use solvent
type cleaners on webbing as this may weaken the
fibers or affect the original dye or when fraying takes
place replace belt.
Advertisement
Table of Contents
