Table of Contents
Advertisement
Crusader
MC-8
[
3-20 -
PAGE _ _ _ _ _ _ _ _ DATE
MAINTENANCE
December, 1976 ]
MANUAL
:Y.
35
- 19
--i
5
* Effective Unit No. 31618 the Deflector was deleted.
5. Bracket Only - R.H.
17. Cap-Ball Stud
6. Bracket Only - L.H.
18. Machine Screw
7. Stud
19. Set Screw
8. Roll Pin - 1/8 x 1/2
20. Washer
11. Arm Only - R.H.
21. Washer
12. Arm Only - L.H.
22. Spring
13. Spring Retainer
23. Spacer - Arm to Bracket
14. Spring
24. Castle Nut
15. Seat - Ball Stud
25. Cotter Pin
16. Ball Stud
26. Cap Nut
Figure 3-14: Exterior Rear View Mirrors
33
36
30
29
27. Machine Screw
29. Bezel
30. Glass Only
31 • Back - R . H .
32 • Back - L. H .
33. Rubber Bumper
34. Set Screw
35. Air Scoop
36. Convex Mirror
ADJUSTING MIRROR ARM STOPS
DISASSEMBLY OF MIRROR ARM
31
At inside of mirror arm, loosen lock nut retaining
bumper screw to arm. With mirror arm to bracket
tension slack, swing arm each way to extreme end of
travel, touching coach body, windshield or window
glass. Turn out bumper screw to provide sufficient
clearance to prevent glass, body or mirror damage.
Secure bumper screw by tightening bumper screw
lock nut.
At mirror end of arm, loosen set screw (12) to
relieve spring tension on ball stud
(7).
Remove _four
screws (5) which attach ball stud cap (6) to mirror
arm (11 ). Remove cap, ball stud
(7),
ball stud seat
(8), spring (9) and spring retainer (10) from ~rm. At
bracket end of arm, remove screw (14) attaching cap
nut (15) to arm stud (21). Remove cap nut. Rem_ove
cotter pin (13) from jam nut (16) remove nut, fibre
Advertisement
Table of Contents
