Screw Mounting - HomeMatic HmIP-WTH-1 Installation And Operating Manual

Start-up
G
H
• Remove the protective film from
the adhesive strips.
• Press the assembled wall thermos-
tat with the back side to the wall in
the position where it should subse-
quently be attached.

6.2.2 Screw mounting

For mounting the wall thermostat by
screws, please proceed as follows:
• Choose a site for installation.
Make sure that no electricity or
similar lines run in the wall at this
location!
• Position the mounting plate (F) on
the desired site on the wall. Make
sure that the arrow on the moun-
ting plate is pointing upwards.
• Use a pen to mark the positions of
bore holes (J) (diagonally opposite)
in the mounting plate on the wall.
J I
J I
• Now drill the bore holes.
If you are working with a stone
wall, use a 5 mm drill bit for the
wall plugs supplied. If you are
working with wooden walls, you
can use a 1.5 mm drill bit to make
it easier to screw in the screws.
• Use the supplied screws and plugs
(K) to fasten the mounting plate to
the wall.
K
• Attach the clip-on frame (A) to the
mounting plate.
K
21