Mounting; Removing The Thermostat - HomeMatic Evo Mounting Instruction And Operating Manual

5.2

Mounting

Please read this entire section before starting to
mount the device.
The Homematic IP Radiator Thermostat is easy to install,
and can be done without draining heating water or in-
tervening in the heating system. No special tools are re-
quired, nor does the heating have to be switched off.
The metal nut (A) attached to the radiator thermostat
can be used universally and without accessories for all
valves with a thrad size of M30 x 1.5 from the most pop-
ular manufacturers. You can find an overview and further
information about compatible manufacturers and valve
adapters at www.homematic-ip.com.
By means of the adapters in the delivery, the device can
also be installed on radiator valves of type Danfoss RA,
Danfoss RAV and Danfoss RAVL (see "5.2.4 Adapter for
Danfoss" on page 50).
5.2.1

Removing the thermostat

In case of visible damage of the existing radiator,
valve or heating pipes, please consult a specialist.
Remove the old thermostat dial from your radiator valve:
• Rotate the thermostat dial to the maximum value
(1) anti-clockwise (see fig. 6). The thermostat dial
Start-up
47