Mounting - HomeMatic HmIP-eTRV-C Mounting Instruction And Operating Manual

• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
• If teaching-in was successful, the LED (C) lights
up green. The device is now ready for use. If the
LED lights up red, please try again.
• In the app, give the device a name and allocate
it to a room.
• Do not yet close the battery compartment (see
„5.3 Adaption run" on page 48).
5.2

Mounting

Please read this entire section before starting to
mount the device.
The Homematic IP Radiator Thermostat is easy to install,
and can be done without draining heating water or in-
tervening in the heating system. No special tools are re-
quired, nor does the heating have to be switched off.
The metal nut (A) attached to the radiator thermostat
can be used universally and without accessories for all
valves with a thread size of M30 x 1.5 from the most
Start-up
41