Installation; Adhesive Strip Mounting - HomeMatic HmIP-WTH-1 Installation And Operating Manual

Start-up
You can manually start the pairing
mode for another 3 minutes by
pressing the system button (D)
briefly.
Your device will automatically appear
in the Homematic IP app.
• To confirm, enter the last four di-
gits of the device number (SGTIN)
in your app, or scan the QR code.
The device number can be found
on the sticker supplied or attached
to the device.
• Wait until pairing is completed.
• If pairing was successful, the LED
lights up green. The device is now
ready for use.
• If the LED lights up red, please try
again.
• Select the desired solution for your
device.
• Allocate the device to a room and
give the device a name.
• The configuration is then carried
out in the Homematic IP app.
6.2

Installation

Please read this entire section
before starting the installation.
You can use the supplied clip-on frame
(A) to mount the wall thermostat or ea-
sily integrate it into an existing switch
(see „6.2.4 Installation in multiple combi-
nations" on page
If you want to mount the wall thermo-
stat with the supplied clip-on frame,
you can use
• the supplied double-sided adhesive
strips or
• the supplied screws
to fix it to a wall.
You can also mount the wall thermos-
tat on a flush-mounting box.

6.2.1 Adhesive strip mounting

For mounting the assembled wall ther-
mostat with the adhesive strips, please
proceed as follows:
• Choose a site for installation.
Make sure that the mounting sur-
face is smooth, solid, non-distur-
bed, free of dust, grease and sol-
vents and not too cold to ensure
long-time adherence.
• Fix the adhesive strips (G) on the
back side of the mounting plate
(F) in the provided area. Make sure
that you can read the letters on the
back side (H) and that the clips on
the mounting plate latch into the
openings on the wall thermostat.
23).
20