Mounting - HomeMatic HmIP-eTRV-C-2 Mounting Instruction And Operating Manual

Start-up
• Do not yet close the battery compartment (see
„5.3 Adaption run" on page 48).
5.2

Mounting

Please read this entire section before starting to
mount the device.
The Homematic IP Radiator Thermostat is easy to install,
and can be done without draining heating water or in-
tervening in the heating system. No special tools are re-
quired, nor does the heating have to be switched off.
The metal nut (A) attached to the radiator thermostat
can be used universally and without accessories for all
valves with a thread size of M30 x 1.5 from the most
popular manufacturers such as Heimeier, MNG, Junkers,
Landis&Gyr (Duodyr), Honeywell-Braukmann, Oventrop,
Schlösser, Comap, Valf Sanayii, Mertik Maxitrol, Watts,
Wingenroth (Wiroflex), R.B.M, Tiemme, Jaga, Siemens
and Idmar.
By means of the adapters in the delivery, the device can
also be installed on radiator valves of type Danfoss RA,
Danfoss RAV and Danfoss RAVL (see „5.2.3 Adapter for
Danfoss" on page 44).
42