General System Information; Start-Up; Pairing The Homematic Ip Access Point - HomeMatic HmIP-WTH-1 Installation And Operating Manual

General system information

5 General system information
This device is part of the climate con-
trol solution of Homematic IP and
works with the Homematic IP radio
protocol. All devices of the climate
control solution can be configured
comfortably and individually with a
smartphone via the Homematic IP app.
The available functions provided by the
Homematic IP system in combination
with other components are described
in the Homematic IP User Guide. All
current technical documents and up-
dates are provided at
www.homematic-ip.com.

6 Start-up

Please read this entire section
before starting the pairing proce-
dure.
For more information on teaching
and setting up the wall thermostat
using a CCU3, please refer to the
WebUI manual on our homepage
at www.homematic-ip.com.
The wall thermostat must first be
added in order to be able to com-
municate with other devices in your
system. To control your heating,
you can teach the wall thermostat
to the Homematic IP Access Point
as described in (see „6.1 Pairing the
Homematic IP Access Point" on page
19).
6.1 Pairing the Homematic IP Access
Point
First set up your Homematic IP
Access Point via the Homematic IP
app to enable operation of other
Homematic IP devices within your
system. For further information,
please refer to the Access Point
operating manual.
To add your wall thermostat to the ac-
cess point, please proceed as follows:
• Open the Homematic IP app on
your smartphone.
• Select "Add device".
• To remove the electronic unit (B)
from the frame, take hold of the
sides of the electronic unit and pull
it out.
• Turn over the electronic unit (B).
• Remove the insulation strip from
the battery compartment of the
wall thermostat.
• The pairing mode is active for 3
minutes.
19