Setup - Gateway Screens; Ethernet/Ip Fieldbus Screens - Graco CGM Instructions And Parts

c. Mount CGM (A) on base (B) with two screws
(C).
2. Install access cover (D).
3. Connect CAN cable from either CAN connection on
the CGM to the CAN connection found on the CGM
to the CAN connection found on the bottom of the
ADM.
4. If used, connect the ethernet, DeviceNet, or
PROFIBUS cable to the CGM as applicable.
Connect the other end of the cable to the FieldBus
device.
CGM Interface Manual, HFR/ NVH (Small Map with Data Exchange) Applications, March 25, 2022, Page 4 of 23
5. Perform the Install or Update Data Map procedure in
CGM manual 312864.
6. See Available Internal Data for details on FieldBus
pinout setup.
7.
Perform Setup to configure the fieldbus.
Setup – Gateway Screens
The Gateway screens are used to configure the fieldbus.
These screens are shown only if a CGM is correctly installed in
your system. See Installation.
1. With the system on and enabled, press
access the Setup screens.
2. Press the left arrow key once to to navigate to the
main Gateway screen. See Fig. 10.

EtherNet/IP Fieldbus Screens

These screens are shown only if you have a EtherNet/IP
Fieldbus CGM installed.
Screen 1
This screen enables the user to set the IP address,
DHCP settings, subnet mask, gateway, and DNS
information.
Screen 2
This screen displays the hardware revision, system
serial number, and data map identification information.
to