Table of Contents
Advertisement
Setup
To prevent damage to soft key buttons on the ADM, do
not press the buttons with sharp objects such as pens,
plastic cards, or fingernails.
Gateway Screens
Use the Gateway screens on the ADM to configure the
fieldbus. These screens are shown only if a CGM is cor-
rectly installed in your system. See Installation on page
3.
1. With the system on and enabled, press
ADM to access the Setup screens.
2. Use the ADM's arrow keys to navigate to the main
Gateway screen.
EtherNet/IP Fieldbus Screens
NOTE: These screens are shown only if you have an
EtherNet/IP fieldbus CGM installed.
Screen 1
Press the
key to access this screen. Use the arrow
keys to navigate to each field and the keypad to set the
IP address, DHCP settings, subnet mask, gateway, and
DNS information.
3A5186B
NOTICE
Screen 2
Use the down arrow key on the ADM to navigate to
screen 2. This screen displays the hardware revision,
system serial number, and data map identification infor-
mation.
on the
DeviceNet Fieldbus Screen
NOTE: This screen is shown only if you have a Devi-
ceNet fieldbus CGM installed.
Press the
the device address and baud rate. You can also view
the hardware revision, system serial number, and data
map identification information.
key to access this screen. You can set
Setup
5
Advertisement
Table of Contents
