Setup - Graco Dispensit 710 Instructions Manual

Setup

Setup
NOTE: See Typical Installation diagram.
1. Perform Setup procedure for feed system
2.
components. See feed system manual(s).
2. Place an in-line air pressure regulator, air-water
separator/filter, and shut-off/bleed valve between
the air supply and the control solenoids.
Typical Installation
Material Tank (optional)
Pump
F . 1
IG
6
3. Connect each 1/4 in. outside diameter supplied air
line to the corresponding control solenoid. See Typ-
ical Feed System Components starting on page 7.
4. Connect chemical lines from feed system to
metering valve material inlets. See Typical Feed
System Components starting on page 7.
Air Supply
Fluid Shut-Off Valve
User Supplied
Air Shut-off and Bleed Valve
Air-Water Separator/Filter
Air Pressure Regulator
Control Solenoids
Metering Valve
332094C