Setup Screens - Graco E-Flo 24P821 Instructions-Parts List Manual

Setup Screens

Setup Screens Screens
Setup Setup Screens
Use the Setup screens for pump
settings and accessory features. See
Screen Navigation and Editing, page 8
information on how to make selections and enter
data.
Inactive fields are grayed out on a screen.
NOTE: NOTE: Before setting up profiles on Setup Screens NOTE:
1–4, perform the initial setup on Setup Screens 5–22
to establish the configuration for your system and
affect the displayed data.
12
Setup Screen Setup Setup
for
Use this screen to set the operating mode for a
selected pump and profile.
Figure 11 Setup Screen 1
Screen 1 1 1 Screen
Setup Setup Setup Screen Screen 1 1 1 Key Screen
For systems with multiple pumps and
one display, select the pump (1 to 8)
from the menu.
NOTE: Three phase systems do not
support multiple pumps.
Select the profile (1 to 4) from the menu.
Select the operating mode
(force/pressure or flow) from the
menu.
• In force/pressure mode, the motor
adjusts the pump speed to maintain
the fluid pressure percentage set on
Setup Screen 2. If the flow limit is
reached before the target pressure,
the unit stops driving to the pressure
(if set as an alarm).
• In flow mode, the motor maintains
a constant speed to maintain the
target flow rate set on Setup Screen
3, regardless of the fluid pressure,
up to the pump's maximum working
pressure.
If the system is equipped with a back
pressure regulator (BPR), set the target
air pressure to the BPR from 0 to 100
percent (approximately 1 to 100 psi).
Leave the field set to 000 for a system
with no BPR. This value represents the
percentage that is closed on the BPR. If
the value is greater than zero but there
is no BPR system, the L6CA error code
appears.
This softkey is disabled by default, and
Profile Lock
only appears if the Profile Profile
checked on Setup Screen 22, page
Press to activate the profile that you just
edited.
Key Key
Lock box is
Lock
22.
3A2527H