Table of Contents
Advertisement
Chapter 2
C.
Line Spacing
Justify (JUST) Printing M o d e
This mode will print each line so that the last
character is printed on the right margin.
The typed characters will first appear on the L C D
Display (at this time the characters can be edited
before they are printed).
When further input will exceed the right margin the
characters will be printed on the paper.
For this reason, you need only press the RETURN
Key when you wish to enter a permanent Carriage
Return.
If the RETURN Key is pressed, the characters typed
up to that point will be printed without being justified.
•Justified printing will start only when the cursor is at
the last character position on a line.
• I n the Justify Printing Mode, Automatic Carriage
Return setting does not function.
This selects the amount of paper that is fed each time
the RETURN Key is pressed.
•Setting
Press the 1 Key together with
the CODE Key.
Each
time
these
keys
are
pressed, the " A " mark on the
L C D Display alternates be-
tween " 1 " , "IVz" and " 2 " .
Set the line spacing to the
desired mode.
1
Paper is fed by 1 line.
If the operation is interrupted and/or the buzzer
sounds continuously turn the unit off and then on. If
the unit does not return to normal operation and/or
the buzzer still sounds check to see if the Ribbon
Cassette or the Correction Tape has reached its end.
1
1
/2
Paper is fed by one and a half lines.
2
Paper is fed by 2 lines.
01
Advertisement
Chapters
Table of Contents
