REPLACING THE CUPWHEEL™
1 - 3
PRINTING ELEMENT
4
Close the Top Cover again and place the Type-
writer on its back.
Remove the Bottom Cover Lid by sliding it to the
right side.
1
Set the POWER Switch to the " O F F " position.
Remove the AC Power Cord from the Power
Input Jack.
2,
Hold both sides of the Top Cover and open it.
3
Using your hand, gently move the Carriage to the
right side.
5
Grasp the Lever of the Cupwheel
Printing
Element between your fingers to release the lock.
Then pull it directly out as shown in the figure.
RSI
Cupwheel
Printing Element
Lever