Panasonic RK-T25 Operating Instructions Manual page 54

OTHER
Symptom
Cause
Remedy/check
Reference
page
Check to see if there is any foreign
matter in the carriage mechanism.
" C A R R I . INIT E R R " appeared on
the LCD Display.
Connect the AC Adaptor and check the
operation of the unit.
8 - 1 0
" C A R R I . INIT E R R " appeared on
the LCD Display.
Check to see that the Ni-Cd Battery
Pack is correctly connected.
8 - 1 0
When the buzzer
Charge the Ni-Cd Battery Pack.
8 - 1 0
sounds, a
message will
appear on the
" W H E E L INIT E R R " or " W H E E L
STOP E R R " appeared on the LCD
Display.
Check to see that the Cupwheel Print
Element is installed.
12, 13
LCD Display,
and the unit will
" W H E E L INIT E R R " or " W H E E L
STOP E R R " appeared on the LCD
Display.
Re-install the Cupwheel Print Element.
12, 13
cease to operate.
"RIBBON INIT E R R " or
"RIBBON STOP E R R " appeared on
the LCD Display.
Re-install the Ribbon Cassette.
14, 15
"RIBBON INIT E R R " or
"RIBBON STOP E R R " appeared on
the LCD Display.
Replace the Ribbon Cassette with a
new Cassette.
14, 15
"PLATEN INIT E R R " or
" P L A T E N STOP E R R " appeared on
the LCD Display.
Check to see if there is any foreign
matter adhering to the platen.
"PLATEN INIT E R R " or
" P L A T E N STOP E R R " appeared on
the LCD Display.
Charge the Ni-Cd Battery Pack.
ANY TIME YOU PLACE YOUR HANDS NEAR
THE INSIDE OF THE UNIT MAKE SURE THAT
THE AC ADAPTOR IS DISCONNECTED AND THE
POWER SWITCH IS IN THE "OFF" POSITION.