Tools And Test Equipment - GE Innova IGS 520 Preinstallation Manual

3.2 Tools and Test Equipment

Refer to Table
Table 1-2, refer to the appropriate component Pre-Installation Manual listed in
Innova System
Table 1-2:
PRODUCT OR COM‐
PONENT
Innova LC Positioner
Status Display
Omega/Tilting table
C2 Cabinet
X-Ray Head
C1 Cabinet
Chapter 1 General Requirements
Innova IGS 520, Innova
TM
1-2. To obtain a list of tools and test equipment for components not specified in
Compatibility.
TOOL OR TEST EQUIP‐
MENT
Service Engineer's Tool
Case
Level, Protractor Type
Plumb Line included in
46-216640G1
Torque Wrench 2 to 20
daN.m (15 ft. lbs. to 150
ft. lbs.)
1/2 inch Ratchet Wrench
(2)
Wrench, Spanner
(46-176584P1)
Laptop Computer (MS-
DOS Windows)
Same as for Innova LC (Service Engineer's Tool Case)
Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Installation dolly (PN
5265134)
Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Same as for Innova LC (Service Engineer's Tool Case) Fill in any additional tools or test equipment as
required
Ethernet adaptation kit
for laptop 2128794
IGS 530, Innova
TM
USED FOR
General Use
Positioner Checks
Positioner Checks
Positioner Checks
Raise and Lower Posi‐
tioner shipping dolly
High Voltage Cable In‐
stallation
Positioner Configura-tion
and Calibration
Replacing Omega with
Tilting table
General use (to be or‐
dered before delivery of
system)
IGS 540 Pre-Installation Manual
TM
Direction 5499972-1-1EN, Revision 2
Chapter 2, Basic
SOURCE RECEIVED (DATE)
37