Care And Cleaning; Disassembling The Juicing System - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

Problem Reason The Solution
The pulp is very You are pushing too Do not apply too much pressure when pushing down your food.
wet. You get an fast and with too Push your food slowly and evenly down the feed chute.
insufficient amount much pressure on
of juice. the food pusher.
The mesh in the Remove excess fibre building up in the mesh and blocking the
juicing sieve is fine pores. Rinse the juicing sieve (see: 'Emptying the Contai-
clogged. ners and Removing Obstacles'). Try to process fibrous foodstuffs
in turn with soft and juicy ingredients.
Only little amount of The amount of juices you can get from individual batches of
juices in your food. ingredients may vary to a high degree (see: 'Tips for Juicing').
You are processing Some types of fruit (e.g. mangoes, quinces) will only give off
a type of fruit that there juices when squeezed (see: 'Tips for Juicing').
is not suited for this
kind of juicer.
Excessive pulp is The pulp guttering is Switch "OFF" the Juicer and unplug from the power supply.
building up in the clogged. Remove the obstacle according to the instructions in section
juicing sieve. 'Emptying the Containers and Removing Obstacles'.
The selected speed Select a higher speed level.
is to low.
Too much pressure Press evenly and slowly onto the food pusher.
on the food pusher.
You are processing Switch "OFF" the Juicer and unplug from the power supply. Cle-
very fibrous food- an the juicing sieve according to the instructions in section 'Emp-
stuffs. tying the Containers and Removing Obstacles'. Try to process
fibrous foodstuffs in turn with soft and juicy ingredients.
No juice. The juicing sieve is Switch "OFF" the appliance and unplug from the power supp-
clogged. ly. Clean the juicing sieve (see: 'Emptying the Containers and
Removing Obstacles').
The drip-stop is Turn the stainless steel sleeve at the juice spout by 180° to
closed. open the drip-stop (see: 'Drip-Stop Feature').
The selected speed Select a higher speed level.
is to low.
You are processing Some types of fruit (e.g. mangoes, quinces) will only give off
a type of fruit that there juices when squeezed (see: 'Tips for Juicing').
is not suited for this
kind of juicer.
78

CARE AND CLEANING

WARNING: Always ensure that all parts of the appliance are out of reach of
young children. Always switch OFF (turn the selection dial to the "OFF" position,
switch the power switch to "O") and unplug the appliance, before cleaning the
appliance.
Do not spill or pour any liquids on or in the motor base or power cord. Do not
place or immerse the motor base or power cord in any liquids to avoid damage,
risk of fire, and electric shock. Keep the motor base always completely dry and
clean.
Do not use abrasive cleaning agents or aggressive cleaners (e.g. bleach, sol-
ving agents) for cleaning the appliance or any part of it, to avoid damage to the
surfaces. Do not use any hard or sharp-edged objects for cleaning (e.g. scoring
pads, metal cooking utensils). Do not use violence!
DO NOT place the motor base or power cord in an automatic dishwasher!
Clean the appliance and accessories always immediately after use, to avoid the
build-up of stubborn residues and discolouration. Do not store your food in the con-
tainers of the appliance.

DISASSEMBLING THE JUICING SYSTEM

After operation, you should always disassemble the juicing system, empty the pulp
container and juice jug, and rinse all parts at once to avoid discolouration of the
plastic parts and food drying on the surfaces. For this, proceed as follows.
WARNING: The blades in the base plate of the juicing sieve are very sharp.
Always handle the juicing sieve by the rim or the dark drive coupling.
Tip: It is good advice to hold a sufficiently large tray at hand for placing the parts
of the juicing system on it. This may keep your working space clean.
1. Ensure that the selection dial is turned to the "OFF" position (display is dark), the
power switch at the rear of the appliance is switched off ("O"), and the motor
is idle. Unplug the appliance.
2. Remove the juice jug. To avoid that juices still drip out of the juice spout, turn the
drip-stop at the juice spout by 180°. Slowly empty the juice jug.
3. Push the locking arm out of the support on the juicer cover and lower the locking
arm to the horizontal position.
4. Lift the juicer cover upwards to remove it.
79