Juicing System - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

JUICING SYSTEM

Problem Reason The Solution
The juice collector The pulp container is Place the pulp container onto the pulp container protrusion at
does not fit onto the not placed correctly the bottom of the motor base. If positioned correctly, it will fit
motor base. at the side of the closely to the side of the motor base.
motor base.
Wrong orientation of The juice spout of the juice collector must fit into the groove
the juice collector. at the motor base and the pulp guttering must fit into the pulp
container. Position the juice collector accordingly.
The juicing sieve is Remove the juicing sieve from the drive rotor. The juice collector
still mounted on the is always mounted BEFORE inserting the juicing sieve.
drive rotor.
You cannot close The juicing sieve is Remove the juicer cover. Turn the juicing sieve without pressure
the gap between not engaged at the over the drive rotor until the juicing sieve slides down easily.
juice collector and drive rotor. Then push down the juicing sieve slightly to make it engage
juicer cover. tangibly on the drive rotor.
The pulp container is Place the pulp container on the protrusion at the bottom of the
not positioned cor- motor base. Otherwise, the pulp guttering of the juicer cover
rectly. cannot slide into the pulp container.
You cannot fix the The juice collector Ensure that the juice collector and juice cover are mounted tight-
locking arm in its or juicer cover is not ly and without any gaps.
upper locked posi- mounted correctly.
tion.
The juicing sieve is Remove the juicer cover and turn the juicing sieve to and fro on
not locked to the the drive rotor until it slides down. Then push the juicing sieve
drive rotor correctly. down gently. It must engage tangibly on the drive rotor. The-
reafter mount the juicer cover again. There may be no gap bet-
ween juicer cover and juice collector. Try again.
76
Problem Reason The Solution
Liquids run over the The juice collector Immediately unplug the appliance. Clean and dry the appliance
rim of the motor or juice spout is (see: 'Cleaning the Juicing System') and leave the motor base
base and/or are blocked. dry naturally for 1 day.
accumulating under Always ensure to turn the drip-stop at the juice spout of the
the motor base. juice collector open before juicing (see: 'Drip-Stop Feature').
Check the juice collector for any obstacles (see: 'Emptying the
Containers and Removing Obstacles').
The pulp container is Immediately unplug the appliance. Clean and dry the appliance
overfilled. (see: 'Cleaning the Juicing System') and leave the motor base
dry naturally for 1 day.
Do not overfill the pulp container or juice jug during processing
(see: 'Emptying the Containers and Removing Obstacles').
The juicing sieve is Immediately unplug the appliance. Clean and dry the appliance
overfilled. (see: 'Cleaning the Juicing System') and leave the motor base
dry naturally for 1 day.
Do not overfill the feed chute. Do apply too much pressure onto
the food pusher during juicing (see: 'Emptying the Containers
and Removing Obstacles' and 'Method of Operation and Making
Breaks').
Juice sprays out and Some juices are Do not apply too much pressure. If possible, process this type of
splashes at the juice very frothy, causing food in combination with other foodstuffs.
spout. splashing at the jui-
ce spout.
The drip-stop is not Ensure to open the drip-stop by turning the stainless steel sleeve
completely open. at the juice spout (see: 'Drip-Stop Feature').
77