Solving Problems - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

7. Re-assuming juicing:
Hold the pulp container tilted and push it under the pulp guttering of the juice
collector. May be, you need to lift the juice collector a little. Ensure that the pulp
guttering is reaching over the rim into the pulp container (see: 'Mounting the Jui-
cing System').
Wipe dry the juicing sieve thoroughly – especially the drive coupling. Replace
the juicing sieve and push it down slightly onto the drive rotor. Then replace the
juicer cover. Lift the locking arm and push the locking arm into the support at the
juicer cover. Ensure to open the drip-stop (dark bar on the stainless steel sleeve
is facing towards you). Replace the juice jug.
8. Thereafter, you may continue juicing.

SOLVING PROBLEMS

Many problems occurring during operation may be solved easily by observing the
hints, given in 'Properties of Your New Multi Juicer', 'Tips for Best Results' and 'Ope-
ration'. Additionally, you will find solutions in the following table.
GENERAL PROBLEMS
Problem Reason The Solution
The display stays The appliance is not Check, if the power plug is inserted in an appropriate wall
dark and the motor live. power outlet and the used power outlet is live (connect a
does not move, alt- lamp).
hough a speed is
The power switch at First turn the selection dial to "OFF". Then switch the power
selected.
the rear of the appli- switch at the rear of the appliance to position "I". Try again.
ance is switched to
"O" (off).
The automatic shut- After 20 minutes or more in operational mode (switched on
off is active. with a speed selected), the automatic shut-off is activated (see:
'Automatic Shut-Off'). Simply select another speed for re-acti-
vating the appliance.
72
Problem Reason The Solution
During operation, a This may occur duri- There is no need for concern. However, if the problem persists
slightly burnt smell ng the first run of even after repeated usage, get in contact with an authorized
is escaping from the the motor and usu- service centre.
appliance. ally stop after some
time of operation.
During operation, Immediately unplug the appliance. Always unwind the power
loops of the power cord completely (approx. 110cm) to avoid overheating. Check
cord have been still the complete power cord for damage (e.g. molten or brittle
wound around the parts, discolouration). If in doubt, get in contact with an authori-
cord storage at the sed service centre for examination and repair.
bottom of the motor
base.
Liquids ran into the Immediately switch off (selection dial to "OFF", power switch
motor base. to "O") and unplug. Clean the appliance and leave the appli-
ance dry naturally for at least 1 day. If the problem persists, get
in contact with an authorized service centre.
The motor is over- Leave the appliance cool down for at least 1/2 hour.
heated.
73