Table of Contents
Advertisement
5.2.6
Status display
Abrupt changes in the measured acceleration values are signaled in two ways:
• The LEDs "ACC1", "ACC2" and "ACC3" flash:
"ACC1" for the x-direction, "ACC2" for the y-direction, "ACC3" for the z-direction.
• The bits "Slope detected" in the process data are set synchronously with the LEDs.
You can use the LEDs for a quick function test after assembly. See chapter Function test [} 22].
Setting the sensitivity
You can set the sensitivity of the status display for each channel individually in the parameters 80n0:1E
"Slope detection sensitivity".
Value
0
1
2 (factory setting)
3
4
65535
This setting is stored non-volatile in the device. For a function test after assembly, you can therefore set the
sensitivity in advance according to the expected vibrations.
EP3751-0160
Name
Very high
High
Medium
Low
Very low
Off
Version: 1.0
Commissioning and configuration
33
Advertisement
Table of Contents
