Measuring Range - Beckhoff EP3751-0160 Documentation

5.2.1

Measuring range

You can set the measuring range in parameter F800:11 "Range". In the factory setting the measuring range
is ±2 g.
This setting applies to all three acceleration axes.
Possible values for "Range":
Value
0 (factory setting)
1
2
Influence on resolution and noise
If the parameter 80n0:0B "Enable Vendor Calibration" is set to FALSE, a change of the measuring range
also influences the resolution of the measured values and the measured value noise of the respective
channel.
In the factory setting "Enable Vendor Calibration" is TRUE.
See chapter Measured value resolution [} 28].
EP3751-0160
Measuring range
"+-2G"
"+-4G"
"+-8G"
Version: 1.0
Commissioning and configuration
27