Table of Contents
Advertisement
72
4. Network
Connecting to Other Devices via LAN
The unit can connect to smartphones, tablets,
and other control devices via LAN connection
using the LAN function of the unit.
Making a LAN connection between a device
and the unit enables the following using the
"Monitor & Control" application.
• Remote control
You can control the unit from a smartphone
or tablet that is connected to the unit via a
LAN.
• File transfer
You can transfer a proxy clip (low resolution)
or original clip (high resolution) that is
recorded on a memory card in the unit to a
server via a LAN.
• Video monitoring
You can monitor the camera image or
playback video of the unit using the
"Monitor & Control" application on a device.
[Notes]
• Monitoring of the video is not supported with the
following settings.
– Slow & Quick Motion mode
– System frequency of 24
– Interval Rec mode
– When Codec is set to XAVC H-I or XAVC H-L
• Wireless LAN and wired LAN cannot be used at the
same time on the unit.
"Monitor & Control" application
You can use this application to operate the
unit remotely and configure settings of the
unit while monitoring the video from the unit
on the device screen.
For details about the "Monitor & Control" application,
contact your Sony sales or service representative.
Setting the User Name and
Password
Set the user name and password of the unit in
order to use the network function.
1
Set Network Setup >User Name
(page 61) in the Network menu of the
full menu.
2
Set Network Setup >Input Password
(page 61) in the Network menu of the
full menu.
[Tips]
• You can also generate a password automatically.
Execute Generate Password instead of Input
Password.
• The user name and password can be viewed as
text and QR code using Show Authentication.
[Note]
Take care that the QR code and password cannot
be viewed by other people. Specifically, during
X-OCN recording, note that the menu page will be
displayed on an SDI monitor as well as on an HDMI
monitor if you display the QR code or password in
the full menu while the clips screen is open.
Connecting using Wireless LAN
Access Point Mode
The unit functions as an access point, and
connects to a control device via a wireless
LAN.
Smartphone/Tablet
Connecting to a WPS-compatible device
Devices that support WPS can be connected
using WPS.
1
Select Network Setup >LAN Type Select
>WLAN (AP Mode) in the Network menu
of the full menu.
2
Select Wireless LAN >WPS >Execute in the
Network menu of the full menu.
3
Open the device Network Settings or
Wi-Fi Settings, and turn Wi-Fi on.
4
Select the unit SSID from the SSID list in
Wi-Fi Network on the device, then select
WPS Push Button in Option on the device
to connect.
[Notes]
• The operation method differs depending on the
device.
• For the SSID and password of the unit, check
AP Mode Settings >Camera SSID & Password
(page 61) in the Network menu of the full
menu.
5
Connect using the Monitor & Control
application.
[Tip]
You can check the information required for
connecting to the unit using Network Setup >Show
Authentication (page 61) in the Network menu
of the full menu.
Advertisement
Table of Contents
