Table of Contents
Advertisement
76
4. Network: Connecting to the Internet
LAN cable connections and wired LAN
settings
1
Connect the network connector of the unit
and Wi-Fi router using a LAN cable.
2
Turn the unit on.
3
Set Network Setup >LAN Type Select to
Wired LAN in the Network menu of the full
menu.
4
Configure connection settings using
Wired LAN >Detail Settings (page 63) in
the Network menu.
• DHCP
Set the DHCP setting.
When you set to On, the IP address is
assigned to the unit automatically.
To assign the IP address to the unit
manually, set to Off.
• IP Address
Enter the IP address of the unit.
This setting is available only when
DHCP is set to Off.
• Subnet Mask
Enter the subnet mask of the unit.
This setting is available only when
DHCP is set to Off.
• Gateway
Enter the address of the gateway.
This setting is available only when
DHCP is set to Off.
• DNS Auto
Sets whether to acquire DNS
automatically.
When set to On, the DNS server address
is automatically acquired. This setting is
available only when DHCP is set to On.
• Primary DNS Server
Enter the address of the primary DNS
server.
This setting is available only when DNS
Auto is set to Off.
• Secondary DNS Server
Enter the address of the secondary DNS
server.
This setting is available only when DNS
Auto is set to Off.
5
When finished, select Set to apply the
settings.
[Note]
Always select Set after changing the connection
settings. The settings are not applied if Set is not
selected.
Enabling operation from a smartphone
via wired LAN
To operate the unit remotely using the Monitor
& Control application on a smartphone via
Wi-Fi using a Wi-Fi router connected by wired
LAN, set Wired LAN >Camera Remote Control
(page 63) in the Network menu of the full
menu to Enable.
Advertisement
Table of Contents
