Sony BURANO MPC-2610 Operating Instructions Manual page 120

120
7. Appendix: Error/Warning Messages
Display message
Fan Stopped
LENS Error
This Multi Term. acc is not supported
by the device and cannot be used.
Please verify the compatibility.
Failed.
Addition of auto upload job failed.
<SSID>Not found.
<SSID>Authentication Failed
An IP address conflict has occurred.
Please check the network settings.
The IP address of the Wireless LAN
Access Point Mode has been
changed due to an IP address
conflict.
1) "(B)" is displayed for the card in slot B.
Cause and Solution
The built-in fan stopped.
Avoid use at high temperatures, disconnect the power, and
contact your Sony service representative.
A fault was detected in the lens I/F communication when an
E-mount lens is attached.
Check the status of the connection with the E-mount lens.
An incompatible accessory was detected.
The only Multi Terminal accessory supported by the unit is the
supplied grip remote control.
This error may appear if an address cannot be obtained with
DHCP set to On.
Check the DHCP server settings.
The maximum number of transfer jobs has been reached.
Clear any unwanted jobs. The auto upload destination setting
for original clips or proxy clips may also be incorrect. Check
that the setting is correct.
Network (access point) with the specified <SSID> could not be
found.
Check that the setting is correct.
Connection authentication on the network (access point) with
the specified <SSID> failed.
Check that the password and other settings are correct.
There is a conflict in the network addresses of the wireless
LAN, wired LAN, or USB tethering.
Change the address manually or change the settings for the
network router.
The IP address of the wireless LAN access point mode was
changed due to a conflict in the network addresses of the
wireless LAN access point mode, wired LAN, or USB tethering.
Check the IP address setting.