Table of Contents
Advertisement
14
2. Preparation
Setting the Clock
When you use the unit for the first time,
the initial setup screen appears on the LCD
monitor when the power is turned on.
Set the date and time of the internal clock
using this screen.
Time Zone
The value shows the time difference from UTC
(Coordinated Universal Time). Change the
setting as required.
[Note]
When Time Zone is changed, the clock setting changes
according to the time difference.
Setting the Date and Time
Turn the multi-function dial (page 4) to
select items and values, then press the dial to
apply the selection. When you press the dial
when the cursor is on "Set," the setting display
disappears and the clock setting is completed.
After the initial setup screen disappears, you
can change Time Zone and date/time settings
using Maintenance >Clock Set (page 65) in
the full menu.
[Notes]
• If the clock setting is cleared because the backup
battery fully discharged when no power was supplied
(no battery pack and no DC IN connection), the initial
setup display will be displayed when you next turn on
the power of the unit.
• While the initial setup display is shown, no other
operation, except turning the power off, is permitted
until you finish the setting on the screen.
[Tip]
You can also use the multi selector.
Advertisement
Table of Contents
