Table of Contents
Advertisement
16
2. Preparation: Mounting a Lens and Adjusting the Flange Focal Length
Shims
When using circular shims
Attach with the surface that has markings
on it facing the front.
Markings
Markings
4
Reattach the PL connectors (two
locations) to their original positions, and
tighten the four Phillips screws with
0.18 N·m tightening torque.
5
Reattach the PL-mount flange in its
original position, and tighten the six Torx
screws to a tightening torque of 0.35 N·m
using a T8 torque wrench.
Cleaning the Optical Filter
To clean the optical filter, first remove the
adaptor. Exercise care when wiping the
adaptor center part (shaded part) with a cloth
or other material to prevent fibers adhering to
surfaces. If fibers are adhering, wipe off using
a soft brush.
Adaptor
Removing the PL-Mount Adaptor
Remove the PL-mount adaptor when you
want to mount an E-mount lens to the unit.
Attachment/removal is performed with the
rear side of the unit facing down.
Loosen the six hex screws (2.5 mm) and
remove the PL-mount adaptor.
PL-mount
adaptor
[Note]
When attaching/removing the adaptor, take care not to
touch the connector contacts of the unit and PL-mount
adaptor.
[Tip]
Removing the battery and placing the rear side of the
unit face down provides stability.
To attach the PL-mount adaptor
1
Check that the E-mount lever is in the
locked position.
E-mount
lever
2
Place the PL-mount adaptor back in its
original position, insert the six hex screws
(2.5 mm), and tighten the screws to a
tightening torque of 0.8 ± 0.12 N·m using
a hex wrench (2.5 mm).
Advertisement
Table of Contents
