Installation - Siemens SINAMICS S120 Equipment Manual

Booksize power units

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Installation

If a 50 mm wide module or if a DC link component with the appropriate width (e.g. Braking

Module, Control Supply Module, Voltage Clamping Module) is located at the left-hand end

of the drive line-up, then the DC link bridge including all of the screws must be removed.

The screws must not be inserted without a DC link bridge.

For all other power units and DC link components (e.g. Capacitor Module) that are wider

than 50 mm, it is not permissible to remove the DC link bridge.

If this is not carefully observed, this can result in damage and accidents.

Required tools:

● Torx screwdriver T20

● Flat-bladed screwdriver 1 (0.5 – 3.5)

Booksize power units

Manual, (GH2), 06/2008, 6SL3097-2AC00-0BP6

8.3 DC link adapter