Table of Contents
Advertisement
Installing Rear Hard Drives
The SSG-6049P-E1CR60H/L/L+ chassis supports two optional 2.5" hot-swappable hard
drives in the rear of the chassis. These drive are mounted in carriers to simplify their removal
from the chassis. It is not necessary to power down the system before removing these hard
drives.
Installing Hard Drives in the Rear Carriers
1. Remove a rear hard drive carrier by pushing the release button on the drive carrier. This
will extend the drive carrier handle.
2. Use the handle to pull the drive carrier and out of the rear hard drive bay. Remove the
four screws securing the dummy drive to the hard drive carrier and set them aside for
later use.
3. Lift the dummy drive up and out of the carrier
4. Place a 2.5" hard drive into the carrier with the printed circuit board side facing
downward.
5. Secure the hard drive to the carrier with the screws previously set aside.
6. Using the drive carrier handle, push the hard drive and carrier into the rear bay of the
storage chassis.
7. Push the drive carrier into the drive bay until it clicks into the locked position.
Chapter 3: Maintenance and Component Installation
Figure 3-7. Rear HDDs
45
Advertisement
Table of Contents
