Table of Contents
Advertisement
Multi-Point Lock
FM7300 Series and BL7300 Series
Installation Instructions
3
Installation (cont .)
h
Top and Bottom Latch Adjustment
• With the door hung, measure the clearance
between the top and bottom bolts and strikes.
(Figure 15)
Note:
If both measurements equal 1/16" proceed to Step
3i, otherwise proceed with Step 3h as follows:
• Remove the mortise filler cap and discard.
(Figure 16)
• Retract the latches by roting the lever and
opening the door. (Figure 17)
• Using the supplied 1/8" Allen wrench, loosen
the set screw 1/4 turn maximum. This allows
hex rods to rotate during the latch bolt
adjustment. (Figure 18)
1-800-727-5477 • www.sargentlock.com
Copyright © 2017, 2019, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
Figure 17
TOP OF DOOR
BOTTOM OF DOOR
Figure 15
Figure 16
Note location
of set screws.
Figure 18
10
1/16" Bolt to strike clearance.
1/16" Bolt to strike clearance.
A8220D 10/19
Advertisement
Table of Contents
