Assa Abloy SARGENT BL7300 Series Installation Instructions Manual page 9

Multi-Point Lock
FM7300 Series and BL7300 Series
Installation Instructions
3 Installation (cont .)
g Install Bottom Strike (cont .)
Flush Mount (Figure 9)
Mortise the strike into the floor 1/4" deep.
(Optional for 3/8" door to floor gap.)
IMPORTANT
Use a vacuum or compressed air to
clear holes of debris. (Figure 10)
Cross Sectional View
Flush Mount (Figure 11)
2 1/4"
1-800-727-5477 • www.sargentlock.com
Copyright © 2017, 2019, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole
or in part without the express written permission of SARGENT Manufacturing Company is prohibited.
Drill two (2) 3/8"
diameter holes
by 2-1/4" deep.
Chisel the bottom strike
pocket 1" deep to ensure
bolt has full projection.
Figure 9
Use the anchor tool
to set anchors.
Figure 10
Figure 11
Surface Mount (Figure 12)
IMPORTANT
Use a vacuum or compressed air to
clear holes of debris. (Figure 13)
Use the anchor tool
to set anchors.
Cross Sectional View
Surface Mount (Figure 14)
2 1/4"
1"
9
Chisel the bottom strike pocket
1" deep to ensure the bolt has
full projection.
Drill two (2) 3/8"
diameter holes
by 2-1/4" deep.
Figure 12
Figure 13
1"
Figure 14
A8220D 10/19