Table of Contents
Advertisement
ED3400/ED3400A Series
Surface Vertical Rod
Installation Instructions
3
Installation (cont .)
f
Top Latch and Rod
1. Remove cover.
2. Screw top rod into top latch chassis
halfway. (Figure 15)
3. Confirm crossbar arm is NOT in
dogged position.
4. Remove top rod pin from active
chassis and slide top rod into
active chassis. (Figure 16)
5. Attach top latch chassis to door
with screws according
to template.
Note
Use through-bolt screws for fire rated doors.
6. Ensure top latch bolt is fully extended.
7. Rotate rod until upper hole (see detail)
aligns with hole in active chassis and
insert rod adjustment pin.
g
Mount Bottom Rod Assembly
1. Remove cover.
2. Position bottom case on door,
centered on vertical center line.
Raise or lower to achieve gap
indicated for strike application.
(Figure 18)
3. Mark and center punch mounting holes for bottom latch.
4. Drill and tap mounting holes.
5. Screw bottom rod into bottom latch chassis until finger tight.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
1/4"
Mortise applied strikes
Top latch cover
Figure 15
Outside trim mounting screws - Actual size
Cylinder mounting screws - Actual size
1/8"
Surface applied strike
Figure 18
7
Top latch chassis
Top rod
Active Chassis
Rod adjustment pin
Figure 16
Wood: #10 x 1-1/4"
Phillips flat head
(Total = 4)
Metal: #10-24 x 3/4"
Phillips Flat under
cut (Total = 4)
Figure 17
Latch track thresholds
(by others)
1/8"
FM361 04/20
Advertisement
Table of Contents
