Install And Adjust Bottom Rod; Mount Top And Bottom Latch Covers - Assa Abloy Corbin Russwin ED8400 Series Installation Instructions Manual

ED8400 Series
Vertical Rod Exit Devices
Installation Instructions
3 Installation (cont .)
j

Install and Adjust Bottom Rod

Attach bottom rod to bar assembly by slipping hole over stump and secure rod by means of "E" ring. Shut
door. Dog down active case. Insert pin into rod connector. Turn adjustable rod connector by turning
clockwise or counter clockwise until latch bolt just clears strike. Undog device.
Caution
Make certain "E" ring engages slot in stump.
k

Mount Top and Bottom Latch Covers

Bottom Cover
Position above bottom latch frame and align with hole in slide assembly at bottom. Secure with furnished
screw.
Top Cover
Position and secure with screw through bottom hole in top latch frame.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2011, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
"E" Ring
Bottom Rod
Stump
Bottom
Rod
Attach to Latch
Mechanism
Bottom Latch Cover
Pin
Door
Attach to Bottom Latch
Figure 15
Spring
Cover Screw
Cover
Top Latch Cover
Figure 16
11
Bottom
Rod
Pin
Latch Bolt
Strike
Bolt Just Clears Strike
Cover Screw
Cover
FM22 06/19